MAX_Line_Pressure

If using the PC

Also change this value to 10 and 20.


That would get harder shift at middle load.

If you are having problem, and want to MAX out line and shift pressure, this is the way to do it


Adjust like this, this should give you Harder shift and max line pressure.


If you connect to controller and read all value,

Then if you change one value and move to another field the one you leave is automatically saved in controller, no need to save when you are done.


If you do it on the controller display, do like this

Press down until "Shift Firmness"  Press right

Press down until "Line/Pres MAX/MIN" Press right


Press right until "LineHi 1->2" change to -8 

Press right until "PresHi 1->2" change to 4

Now futher right until

Press right until "LineHi 2->1" change to -8 

Press right until "PresHi 2->1" change to 4

And do so until

Press right until "LineHi 4->5" change to -8 

Press right until "PresHi 4->5" change to 4

Press right until "LineHi 5->4" change to -8 

Press right until "PresHi 5->4" change to 4


On the way left renember to save when asked press down.


Also change this 2 settings to get max shift pressure at 100% TPS

"Setup Parameters" -> "Load - TPS Boost" press down until L=TPS/1 * Boost*??  (It is saved automatically)

"Setup Parameters" -> Boost part load" If it is a Turbo car set to 33 if no turbo car set to 1. (Press right to save)

Set MAX Line/Shift pressure


Copyright © All Rights Reserved

OF Gear ApS

Bergthorasgade 2, 4 TV

2300 Copenhagen S

Denmark

info@ofgear.dk