To mount the Engine Oil pressure sensor.

An wire has to be mounted to the board Clich the picture to the left to see in high Resulution

The sensor itself is mounted like on the picture to the right.

The Thread is G 1/4"

It require SW_214 it is still under test, so you have to email me to get it

Goto "Setup Parameters" athen all way down until "Oil 1=on"

Go in here and set to 1 then you get warning if oilpressure drops to below 0.5 bar

Also the Engine Oil pressure is shown on this page.

This will happen if ( Engine RPM > 400 ) AND ( Engine oil pressure is < 0.5 ) bar