How shift firmness works with EGS52
"Rate last shift" can be used as normal. Every shift has 10 different firmness values depending on load.
- Load is the same as torque: 0-100% load = 0-500 Nm. If the car makes more than 500 Nm, 100% is used.
- During a shift the controller limits the engine torque. Example: a 2-3 shift at high throttle with max torque set to 100 Nm uses the 2-3 value at 20% load.
CAN bus parameters
Go to :
| Parameter | Setting |
|---|---|
| Paddle Check | 1 if the car has paddles, 0 if not |
| Torq Check | 1 |
| Delay 3-4 | Delays the 3-4 shift by 200 ms so the engine torque ramps down for a smooth shift |
General EGS52 parameters
All under :
| Parameter | What it does | Standard |
|---|---|---|
| EGS52 Torq at shift | Torque limit during the 1-2, 2-3, 4-5, 5-4, 4-3, 3-2 and 2-1 shifts | – |
| EGS52 Reduction in mS | How long torque is limited. Can be reduced if the gearbox is in good shape. | 500 ms |
| EGS52 Torq 3-4 | Torque limit for the 3-4 shift only (to deal with the 3-4 flare). Normally lower than the others. | – |
| EGS52 3-4 mS | How long torque is limited in the 3-4 shift. Can be reduced if the gearbox is in good shape. | 700 ms |
| EGS52 Load at shift | 0 = firmness follows TPS (less important as torque is limited). 2 = firmness taken at 20% load. | – |
| What to show | On the gear indicator page: 0 = actual Nm, 1 = actual HP, 2 = temperature. 3 and 4 not used. | – |
| GaragePWM | Softness when shifting P→R or N→D | – |
| TimeGarage | Softness when shifting P→R or N→D | – |